What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 26.06.2025 01:06
Can the fuse protect the electronic devices from lightning instead of a surge protector.
2024–10–14 [Omar Gharbi Omar Gharbi ]
A fuse is a non-resetable over current circuit protector.
Has anyone ever made you take off your shirt?
This one hit behind the barn.
These devices are installed between the “hot” and “neutral” and protective ground.
I post the exact comment here.
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
so, what happens?
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
Taylor Swift Wears a Bejeweled LBD for a Celebratory Girls Night Out with Selena Gomez - instyle.com
What does a fuse do?
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
Why would a spouse cheat if the marriage is good?
This is where this question deviates from being a 'generic' question, and becomes more specific.
There are three different concepts here that are getting confused.
2024–10–10[John johnson John Johnson ]
a photo is worth a thousand words.
In schematic diagrams this is the symbol for a fuse:
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
Now when you have a certain ac resistance, then a current flows in a loop.
[old diagram got deleted by accident]
He then describes Rainy Season and Lightning.
What is the message of Ex Machina?
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
the problem then depends on "how fast does the fuse operate?".
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
Here’s where to get free doughnuts on National Donut Day 2025 - Fortune
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
First Sentence:
The MOV will conduct when the voltage exceeds 50% of line voltage.
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
CNN’s Live ‘Good Night, and Good Luck’ Telecast Spurs Special Coverage - Variety
[image of Common-mode choke]
This is 'the assistant's answer'
what exactly is a ‘surge’ protector?
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
Edit 2024–10.
This is the picture of an electronic coil of wire wound around a core of magnetic material.
He then describes the function of a fuse.
He then asserts :
But… the neutral is now “floating” because of the 1 ohm resistance.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
It also is a device that limits the change in current flow.
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
(Dc diagram shown, AC is similar).
Here is a simplified AC power diagram.
eight
Because the load is inductive, the current lags the voltage.(by a bit).
Upvotes:
An AC voltage/ current source, and an ac inductive load.
One
Barnstars:
These are simplified answers to the original question, and does not change anything I wrote above.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
It seems Mohan does not understand the difference between a comment and an Answer.
but I think this circuit , shows a few more pieces.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
The other is “what does a “fuse” do?”
One is “what exactly is in a ‘surge protector’ ? ”
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
2024–10–16 [ OO OLAOYE OYEBODE ]
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
nine
At one ohm, the resistor has a maximum of 1 watt power.
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
The third is lightning and “how it gets conducted into a home.”
But it can get overloaded, and no longer works.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
This is where the MOV conducts again, and dissipated the energy.
This device then solves the entire problem.
A circuit breaker is similar, but is resettable.
but this device (an Inductor) … impedes the rapid changes in the current.
At least they know the answer if they wanted it.
The bolt then partially travels down the line to your home.
There are two important concepts here.
What is lightning?
For this case there are devices called Metal oxide varistors (MOV).
So, the voltage could go up to 500 volts, and the fuse will not open up.